Loading...

All New 3D Walk and 3D Fly Commands in JTS IntelliCAD

3D WALK:

Allows you to view the model as though you are walking through it.

3D FLY:

Allows you to view the model as though you are flying through or around it.

Walking and flying through a drawing:

Drawings can be viewed as though you are walking or flying through them. When you walk through a drawing, you navigate along the xy plane. When you fly through a drawing, you navigate “above” the model, unrestricted by the xy plane.

To walk through a drawing

1 Do one of the following to choose 3D Walk () or 3D Fly ():

  • On the menu, choose View > Walk and Fly > 3D Walk or 3D Fly.
  • On the Walk and Fly toolbar, click the 3D Walk or 3D Fly tool.
  • Type 3dwalk or 3Dfly and then press Enter.

2 Click and drag in the drawing to walk or fly through the model, or use the arrow keys on the keyboard. When finished, release the mouse button.

3 Repeat to walk or fly again.

4 When finished, press Enter, right-click the drawing, or press Esc.

To customize walk and fly settings

1 Do one of the following to choose Walk and Fly Settings ( ):

  • On the menu, choose View > Walk and Fly > Walk and Fly Settings.
  • On the Walk and Fly toolbar, click the Walk and Fly Settings tool.
  • Type 3dwalkflysettings and then press Enter.

2 In Step Size, enter the value for the step size in drawing units, then enter the speed in steps per second.

3 Mark Prevent Clipping if you want to disable clipping.

4 In Lens Length, enter the value for the lens length you want to use. This value applies only when using the 3D Walk and 3D Fly commands; it does not change the default lens length that is determined by the LENSLENGTH system variable.

5 In Walk Elevation, specify the elevation to apply to walk mode during the 3D Walk command.

6 Click OK.